I was inspired by another CM member to head to Home Depot and do a little remodeling of my playroom. Made all of my purchases and headed home and down to the basement. I had to make one additional stop to an industrial plumbing store to pick up a stainless steel urinal shell which would be the centerpiece for my project.  Started out by cutting an oblong hole about 10x8 inches in the face of the urinal and then glued a foam pipe cover around the edge to provide some padding for my subject to be.  Hole was perfect to snuggly and comfortably fit ones face through with chin resting on the lower edge.  The reconfigured urinal shell was then mounted on the inside wall of the basement bathroom so that it looked like it belonged there.  The outer wall of the bathroom faced a storage area with lots of room for the next step. Built a 3x3 base so that if the subject was on their hands and knees, the urinal cut-out would be a perfect chin level.  Once the base was completed, it was covered with a one inch rubber padding and then two heavy duty eyelets were screwed in on each side of the base, so that wrist and angle restraints could be secured to them. Finally, I screwed another eyelet into the stud securing the urinal so that a collar could be attached to the subject and secured to the eyelet.  This would ensure that their head stayed in the urinal opening for their purpose. With the project completed, I admired my work and imagined having a lovely sub in a position.  It was time to give an old friend a call and see if she would be a good submissive and test it out.